Bixby has some of the busiest custom home building in the Tulsa area, from Memorial Drive neighborhoods to acreage south of town. The walls of a new home are one of the best places to invest in insulation, because before drywall every cavity, top plate and window opening can be sealed in a single visit.
Fiberglass batts only work when cut perfectly around every wire and pipe, which rarely happens. Spray foam fills each stud bay completely, seals the gaps where outside air enters, and quiets traffic and weather noise.
We coordinate with your builder so foam goes in after rough-in inspections and before drywall, and we provide a free quote based on your plans.
Bixby tip
Large windows and long exterior walls are common in Bixby custom homes. Make sure window rough openings are sealed with low-expansion foam so the windows are not distorted.
When Wall Spray Foam Makes Sense
- ✓New custom homes before drywall
- ✓Additions and sunrooms
- ✓Garage conversions
- ✓Remodels with open walls
- ✓Media rooms and home offices
- ✓Walls facing busy roads
How Many Inches Go in a Wall?
Open-cell foam fills a 2x4 wall at about 3.5 inches for roughly R-13 and a 2x6 wall at about 5.5 inches for roughly R-20, with a full air seal and good sound control.
Closed-cell foam is usually sprayed 2 to 3 inches deep in walls, adding strength and moisture resistance. A flash-and-batt approach uses about 1 inch of closed-cell with batts behind it to control cost.
Wall Spray Foam Insulation Services We Offer
✓Custom Home Walls
Foam after rough-in, before drywall.
✓Additions and Remodels
Open walls during renovations.
✓Garage Conversions
Turning a garage into living space.
✓Flash and Batt
Budget-friendly hybrid walls.
✓Sound Control
Quieter media rooms and offices.
Wall Spray Foam Insulation Cost in Bixby, OK
| Project | Typical Range | What Affects It |
|---|---|---|
| 2x4 walls, open-cell, per 1,000 sq ft of wall | $1,600–$2,800 | Window count and height |
| 2x6 walls, open-cell, per 1,000 sq ft of wall | $2,500–$4,400 | Custom homes |
| Closed-cell about 2 in, per 1,000 sq ft of wall | $2,000–$4,000 | Higher R per inch |
| Garage conversion walls | Quoted per project | Wall area |
Priced from your plans or a walkthrough.
How It Works
- 1
Plan Review
We review plans with you and your builder.
- 2
Masking
Windows, boxes and floors protected.
- 3
Spray and Trim
Cavities filled and trimmed flush.
- 4
Ready for Drywall
Coverage checked and site cleaned.